Natural Uranium Spectroscopy.

This area is for discussions involving any fusion related radiation metrology issues. Neutrons are the key signature of fusion, but other radiations are of interest to the amateur fusioneer as well.
Post Reply
Ben_Minnix
Posts: 8
Joined: Wed Feb 07, 2018 7:53 pm
Real name: Ben Minnix
Location: Virginia, United States
Contact:

Natural Uranium Spectroscopy.

Post by Ben_Minnix »

Hello, this is probably a pretty simple question but, when performing gamma spectroscopy on natural uranium ore specimens, why do we look for the decay daughters of uranium vs the uranium itself. All of the sample spectra that I have seen look at different daughters and not the specific isotopes of uranium itself. Are the energies too low to detect or what?
User avatar
Richard Hull
Moderator
Posts: 14992
Joined: Fri Jun 15, 2001 9:44 am
Real name: Richard Hull

Re: Natural Uranium Spectroscopy.

Post by Richard Hull »

Gamma spectroscopy of ore has no real gamma signature for uranium beyond some low end, under 100kev, electron shell stuff mostly due to electron shell stuff (XRF) from all the daughter gammas kicking them up from the Uranium. Ore in a gamma spectro is all about the radium daughters. Modern ores can have their uranium percentage content readily determined by counting the radium daughters against a known, graded sample of ore.

Please note that the above information is for a common NaI:Tl crystal gamma spec. of the type the advanced amateur is most likely to be able to have and successfully operate.

Typically, the calibrated sample is in a kit of samples of various percentages in the form of a fine powder. In the kit, is an empty container of the exact size and volume as those of the calibrated samples. The unknown ore is pulverized to a similar powder size, loaded into the empty container. A gamma spectrograph is made of the unknown and printed out. One of the calibrated samples is selected and again a spectrograph is done on it. The gamma pulse heights (counts for significant gamma peaks) are compared and a little simple math can give a rough estimate of the Uranium content percentage in the unknown. If their is a sample in the kit close to what the math says, it is run through the spectro and the unknown ore should be very close as a double check on the math.

I have done this with some calibrated samples I have on some of the Utah ore I have collected.

In the old days, an electroscope was used to determine and ore's percentage of uranium.....Again, this still used the daughter's radiation which is always much more than the uranium radiation. All samples are in powdered form in a controlled volume, both then and now.

Richard Hull
Progress may have been a good thing once, but it just went on too long. - Yogi Berra
Fusion is the energy of the future....and it always will be
The more complex the idea put forward by the poor amateur, the more likely it will never see embodiment
Ben_Minnix
Posts: 8
Joined: Wed Feb 07, 2018 7:53 pm
Real name: Ben Minnix
Location: Virginia, United States
Contact:

Re: Natural Uranium Spectroscopy.

Post by Ben_Minnix »

Thank you very much for the detailed answer. For some reason, there isn't much info on this online. Not sure why, but hey, it is what it is. Again, thanks.
User avatar
Steven Sesselmann
Posts: 2127
Joined: Wed Aug 10, 2005 9:50 pm
Real name: Steven Sesselmann
Location: Sydney - Australia
Contact:

Re: Natural Uranium Spectroscopy.

Post by Steven Sesselmann »

Ben,

Just adding to Richards answer, you can find the common U238 x-rays etc and other isotopes of Uranium here.

http://nucleardata.nuclear.lu.se/toi/nu ... iZA=920238

http://nucleardata.nuclear.lu.se/toi/

A couple of low intensity gamma rays , which are mostly drowned out by other gamma and x-rays from uranium daughters.

Steven
http://www.gammaspectacular.com - Gamma Spectrometry Systems
https://www.researchgate.net/profile/Steven_Sesselmann - Various papers and patents on RG
Post Reply

Return to “Neutrons, Radiation, and Detection (& FAQs)”