HV thyratrons and fusion

This forum is for other possible methods for fusion such as Sonolumenescense, Cold Fusion, CANR/LENR or accelerator fusion. It should contain all theory, discussions and even construction and URLs related to "other than fusor, fusion".
Post Reply
Roberto Ferrari
Posts: 364
Joined: Tue Mar 02, 2004 12:21 pm
Real name: Roberto Ferrari
Location: Argentina
Contact:

HV thyratrons and fusion

Post by Roberto Ferrari »

Hi,

Thinking about John Myers' recent post,I had a slightly mad idea.

The HY-3202 thyratron is loaded with deuterium and the inner pressure is around 15-30 mtorr (as per WiKi), not too far from fusors.
So, working at 30 kV may do some fusion…
All needed to check this is to monitor neutrons close to a high voltage working thyratron.
What you fusorists think about?

Roberto
User avatar
Richard Hull
Moderator
Posts: 14992
Joined: Fri Jun 15, 2001 9:44 am
Real name: Richard Hull

Re: HV thyratrons and fusion

Post by Richard Hull »

If there were neutrons produced by the thyratron, there would have to be a radiation warning on the tube. Pulses are on the order of 1us and the fastest rep rate is typically 1khz. Plus the deuterons are headed in one direction only and that would imply beam on target and there is no target that is deuterated.

I would imagine only a very well tuned 3He tube detector might have a chance of picking any emission out of the noise floor

Richard Hull
Progress may have been a good thing once, but it just went on too long. - Yogi Berra
Fusion is the energy of the future....and it always will be
The more complex the idea put forward by the poor amateur, the more likely it will never see embodiment
Roberto Ferrari
Posts: 364
Joined: Tue Mar 02, 2004 12:21 pm
Real name: Roberto Ferrari
Location: Argentina
Contact:

Re: HV thyratrons and fusion

Post by Roberto Ferrari »

Hi Richard
I am aware of the pulsed mode of operation but estimated that the average power involved was higher than the 500 W of a typical fusor.
About the loaded target I assumed that nickel is a typical support/cage for filaments, good enough to store deuterium during tests and operation life time.
Of course, I realize mine is just a hunch.
Thanks for comment.
Roberto
User avatar
Richard Hull
Moderator
Posts: 14992
Joined: Fri Jun 15, 2001 9:44 am
Real name: Richard Hull

Re: HV thyratrons and fusion

Post by Richard Hull »

Yes, the pulses can range to one million watts peak pulsed power in a ceramic thyratron. However the pulses are going the wrong way and the deuterium gas is not being accelerated during the pulse. The gas is being bulk ionized and used as a conductor. The same goes for mercury in and old thyratron and plain hydrogen. Not all hydrogen thyratrons have deuterium in them.

Richard Hull
Progress may have been a good thing once, but it just went on too long. - Yogi Berra
Fusion is the energy of the future....and it always will be
The more complex the idea put forward by the poor amateur, the more likely it will never see embodiment
Post Reply

Return to “Other Forms of Fusion - Theory, Construction, Discussion, URLs”