More Parts
-
- Posts: 45
- Joined: Tue Oct 14, 2014 6:39 pm
- Real name: Charles Vorbach
More Parts
Just got some KF parts for the chamber. I also got the varaic and hope to wire it up in the next few days.
- Andrew Robinson
- Moderator
- Posts: 688
- Joined: Sun Aug 11, 2013 1:54 am
- Real name: Andrew Robinson
- Location: Raleigh, North Carolina
- Contact:
-
- Posts: 45
- Joined: Tue Oct 14, 2014 6:39 pm
- Real name: Charles Vorbach
Re: More Parts
Still waiting on diodes for rectification, but I put the NST in an insulated box, hooked up the variac, and made a controller for my thermocouple gauge tube based on the Bell Jar's design (http://www.belljar.net/tcgauge.htm).
It uses an op-amp to amplify the thermocouple's voltage to 1 volt full scale and is a nice alternative to buying the controller. I don't have the tube yet, but once I get it I am going to test it/use it to test my vacuum pump. It's an interesting situation, but I think I'll be able to figure it out.
It uses an op-amp to amplify the thermocouple's voltage to 1 volt full scale and is a nice alternative to buying the controller. I don't have the tube yet, but once I get it I am going to test it/use it to test my vacuum pump. It's an interesting situation, but I think I'll be able to figure it out.
-
- Posts: 45
- Joined: Tue Oct 14, 2014 6:39 pm
- Real name: Charles Vorbach
Re: More Parts
Finally got the diodes and hooked up a rough rectification circuit. I am going have to think about how to make it look pretty. Anyway, I will be setting up the voltage divider and meters in the next few days.
- Richard Hull
- Moderator
- Posts: 15037
- Joined: Fri Jun 15, 2001 9:44 am
- Real name: Richard Hull
Re: More Parts
I'm glad to see you used only the proper HV rated wire.
Richard Hull
Richard Hull
Progress may have been a good thing once, but it just went on too long. - Yogi Berra
Fusion is the energy of the future....and it always will be
The more complex the idea put forward by the poor amateur, the more likely it will never see embodiment
Fusion is the energy of the future....and it always will be
The more complex the idea put forward by the poor amateur, the more likely it will never see embodiment
- Bob Reite
- Posts: 579
- Joined: Sun Aug 25, 2013 9:03 pm
- Real name: Bob Reite
- Location: Wilkes Barre/Scranton area
Re: More Parts
!!! Oh that last comment was supposed to be in jest.
The more reactive the materials, the more spectacular the failures.
The testing isn't over until the prototype is destroyed.
The testing isn't over until the prototype is destroyed.
- Andrew Robinson
- Moderator
- Posts: 688
- Joined: Sun Aug 11, 2013 1:54 am
- Real name: Andrew Robinson
- Location: Raleigh, North Carolina
- Contact:
Re: More Parts
"Transparency" read through the Rubbermaid bin
I can wire anything directly into anything! I'm the professor!