FAQ: Vacuum line diagram v2.0

If you have a question about this topic, the answer is probably in here!
Tom McCarthy
Posts: 404
Joined: Wed May 08, 2013 7:36 pm
Real name: Tom McCarthy
Location: Ireland
Contact:

Re: FAQ: Vacuum line diagram v2.0

Post by Tom McCarthy » Mon Jul 28, 2014 9:44 am

Any vacuum valve will do really, you're still in the "dirty" or relatively low vacuum with the roughing pump.

However, it's been a while since I originally posted that diagram and since have been advised that ball valves won't hold up to vacuum scrutiny - they might be applicable in the fore line, but I've been strongly advised not to use them in the high vacuum line. Most angle valves from MDC, Lesker, Pfeiffer etc. are rated for UHV or at least HV so they're sealed for Fusor vacuums anyways.

Hope that helps,
Tom

Aditya Somasundaram
Posts: 5
Joined: Sun Apr 20, 2014 12:41 pm
Real name: Aditya Somasundaram

Re: FAQ: Vacuum line diagram v2.0

Post by Aditya Somasundaram » Wed Jul 30, 2014 8:30 am

Tom,
Thanks for the response!
-Adi

Post Reply