FAQ: Measuring Fusor Voltage - Part I - An Overview

If you have a question about this topic, the answer is probably in here!
User avatar
Richard Hull
Site Admin
Posts: 10904
Joined: Fri Jun 15, 2001 1:44 pm
Real name: Richard Hull

Re: FAQ: Measuring Fusor Voltage - Part I - An Overview

Post by Richard Hull » Sun Jun 08, 2014 5:56 am

Wrong. You would need to scale the circuit proportionally and use a 200 meg resistor for 20kv. In the end you would set the decimal point led on so the display reads xx.xx on a 3 1/2 digit display, which is the most common type. max reading would be 19.99 kv. For 40 kv you would need 4- 100 megohm resistors in series and continue to scale the meter proportionally and set the decimal point light on to read xxx.x so that you would read 39.9 kv, the fourth, left most, 1's digit now becomes useless for 40kv.

Richard Hull
Progress may have been a good thing once, but it just went on too long. - Yogi Berra
Fusion is the energy of the future....and it always will be
Retired now...Doing only what I want and not what I should...every day is a saturday.

Post Reply