Fire extinguisher vacuum chamber

For Short Term Learning Discussions ONLY. This area is for CURSORY questions and connecting with other users ONLY. ALL technical contributions need to be made in the appropriate forums and NOT HERE. All posts are temporary and will be deleted within weeks or months. You should have already search the extensive FAQs in each of the forums before posting here as your question may already be answered.
Post Reply
Zekeww
Posts: 2
Joined: Thu Feb 07, 2019 1:09 pm
Real name: Zeke

Fire extinguisher vacuum chamber

Post by Zekeww » Fri Feb 08, 2019 11:24 am

I was just pondering on the idea, could a used fire extinguisher be used and modified to fit the role of the vacuum chamber for a fusor.
Thanks
Zeke

User avatar
Dennis P Brown
Posts: 1654
Joined: Sun May 20, 2012 2:46 pm
Real name: Dennis P Brown
Location: Glen Arm, MD

Re: Fire extinguisher vacuum chamber

Post by Dennis P Brown » Fri Feb 08, 2019 12:43 pm

Simple answer: no.

Ignoring cleaning issues (not trivial) a fusor (even a demo) require a number of access ports, at the very least. Converting a random piece of metal tubing like a fire extinguisher would require a great deal of work - metal cutting (for ports), welding required port assemblies, and then addition of vacuum accessories (even the threaded section isn't very useful - wrong design for high vacuum work.) Considering these efforts and cost of components, such a project just to bring this sad item up to usefulness, as far as I can see, offers no upside. Getting a piece of clean steel tubing would make far more sense if one really wanted to try and construct such a complex device and they are not concerned about the cutting and welding issues.

If one is just trying to use the existing single access point with no further processing, not a good idea - again, issues with the end thread. However, the point of most fusors is to create a device that offers usefulness - the ability to see the plasma (critical for proper control) and a way to install the essential equipment used to control various parameters. A heavy steel cylinder like that is just a dead end in that case.

As I tell most newbie's here, get a 50 mm diameter std. 4-way cross and build off of that. The extra cost is far out weighed by the ease of adding required accessories since one should already have a decent two stage pump (absolute min. requirement to start any serious fusor type project.)

Post Reply