Will this deuterium generator work well?
Posted: Mon Mar 12, 2018 1:49 pm
(I am not an English speaker, so I might have a problem with my writing. sorry!)
I've been busy for a while, and I'm back here now......with many problem.
Since purchasing deuterium gas is hard work anywhere in the world, I decided to electrolyze heavy water.
Then, I searched the design of the Deuterium Generator in the forum and got the answers I wanted.
(link viewtopic.php?f=6&t=9435&hilit=electrolysis)
This is the PEM Fuel Cell electrolysis device, I have modified it to suit me.
(I confess, I just changed some parts...Thank you very much for your design offer! anyway, I attached rough draft.) And.....here are some simple questions.
Could this design enough to bear the power of vacuum? forum people say it's possible....but I'd like to know more about it.
I plan to use a 9$ Pyrex bottle with a plastic lid as oil bottles.
If I seal the lid and bottle well(glue gun, silicon, or vacuum grease), is it okay to keep the vacuum?
Does this design require a gas regulator? (I don't think it needed....)
lastly, Can the high-pressure needle valve be used as a vacuum valve?
Please let me know if you have any other design problems or tips! (But wait, can I post this kind of question here?)
thanks! 좋은 하루 되세요!
I've been busy for a while, and I'm back here now......with many problem.
Since purchasing deuterium gas is hard work anywhere in the world, I decided to electrolyze heavy water.
Then, I searched the design of the Deuterium Generator in the forum and got the answers I wanted.
(link viewtopic.php?f=6&t=9435&hilit=electrolysis)
This is the PEM Fuel Cell electrolysis device, I have modified it to suit me.
(I confess, I just changed some parts...Thank you very much for your design offer! anyway, I attached rough draft.) And.....here are some simple questions.
Could this design enough to bear the power of vacuum? forum people say it's possible....but I'd like to know more about it.
I plan to use a 9$ Pyrex bottle with a plastic lid as oil bottles.
If I seal the lid and bottle well(glue gun, silicon, or vacuum grease), is it okay to keep the vacuum?
Does this design require a gas regulator? (I don't think it needed....)
lastly, Can the high-pressure needle valve be used as a vacuum valve?
Please let me know if you have any other design problems or tips! (But wait, can I post this kind of question here?)
thanks! 좋은 하루 되세요!