Identifying coax connections etc

Post links to other interesting fusion or alternate energy sites here.
Post Reply
Tom McCarthy
Posts: 404
Joined: Wed May 08, 2013 7:36 pm
Real name: Tom McCarthy
Location: Ireland
Contact:

Identifying coax connections etc

Post by Tom McCarthy » Fri Jan 05, 2018 7:35 pm

I found this webpage helpful for identifying different RF related connections, for coaxial cable and so on. See the attached pdf in case the website goes down.

http://www.rfcables.com/Technical_Connector-Glance.htm


Tech-ConnectorsGlance.pdf
You do not have the required permissions to view the files attached to this post.

User avatar
Richard Hull
Moderator
Posts: 11173
Joined: Fri Jun 15, 2001 1:44 pm
Real name: Richard Hull

Re: Identifying coax connections etc

Post by Richard Hull » Fri Jan 05, 2018 9:12 pm

The PDF above gives only a smattering of connectors.

Two key connectors to be found common in HV RF and NIM in the nuke instrument biz.

HN connectors - This connector is rarely seen at hamfests. If you can find an old one ($5-$10). (new- pasternack $38) Finding one on cabling - Super rare! Almost always a make your own cable situation. Pasternack can charge well over $100 for a 6 footer male-male. Keithley and some Fluke precision, regulated, 0-5000 volt, vacuum tube based, surplus power supplies used only this connector.

SHV-BNC connector Almost never found as a lone connector. New, the simple male connector can cost $30-$50. Pasternack sells a 6 foot male-male coax for $90.00+ You will have to luck out to find a surplus cable. A lot of vacuum HV feed throughs use vacuum tight female SHV's for 10kv+, demanding a male cable be on hand. A lot depends on the area you are in. You might be awash in them in high tech cities with large vacuum and physics research/technical centers. Sadly, in Forest Glen, North Dakota you will find a flask of Romulan ale easier to locate than a surplus SHV-BNC cable.

The adapter seen in the attached image could be a SHV to MHV or SHV to BNC.... both exist and Pasternack gets just under $110.00 for each adapter.

Richard Hull
You do not have the required permissions to view the files attached to this post.
Progress may have been a good thing once, but it just went on too long. - Yogi Berra
Fusion is the energy of the future....and it always will be
Retired now...Doing only what I want and not what I should...every day is a saturday.

Jerry Biehler
Posts: 843
Joined: Tue Nov 24, 2009 8:08 am
Real name:
Location: Beaverton, OR

Re: Identifying coax connections etc

Post by Jerry Biehler » Sat Jan 06, 2018 1:59 am

Also there are two kinds of N connector, 50 and 75 ohm. The difference is the 75 ohm connector has a larger center pin. If you connect a 75ohm N male to a 50ohm female you can damage the 50ohm. That being said 75ohm N connectors are rare as hens teeth so you will probably never see them.

ian_krase
Posts: 508
Joined: Mon Nov 28, 2016 7:48 am
Real name: Ian Krase

Re: Identifying coax connections etc

Post by ian_krase » Sat Jan 06, 2018 9:11 am

Don't forget the Spellman PL259 with long banana-tipped coax extension.

Post Reply