I had a graphite cube 200mm×200mm so i decided to to make something that gives me neutrons all the time, unless I stop it.
I 3d printed a template for some holes in the graphite block , ordered stainless steel tubes 40mm long 6mm diameter, and filled it with some oxides,
Got my small AmBe source and placed it on top, and covered it with HDPE,
I placed the 42-14 neutron detector near it and connected to ludlum model 2200,
The test time was 1 minute
Got 300 counts with this setup,
Now dont kick my az, Specially you Richard.
i like to do experiments, im doing them so no one will.
Neutron generator graphite moderation
-
- Posts: 58
- Joined: Sun May 03, 2020 1:37 pm
- Real name: Sarmad
- Location: Kuwait
- Contact:
- Richard Hull
- Moderator
- Posts: 14992
- Joined: Fri Jun 15, 2001 9:44 am
- Real name: Richard Hull
Re: Neutron generator graphite moderation
Nice little source. I am not sure about Kuwait's nuke regulations, so that is a non-issue here.
Richard Hull
Richard Hull
Progress may have been a good thing once, but it just went on too long. - Yogi Berra
Fusion is the energy of the future....and it always will be
The more complex the idea put forward by the poor amateur, the more likely it will never see embodiment
Fusion is the energy of the future....and it always will be
The more complex the idea put forward by the poor amateur, the more likely it will never see embodiment
- Dennis P Brown
- Posts: 3159
- Joined: Sun May 20, 2012 10:46 am
- Real name: Dennis Brown
Re: Neutron generator graphite moderation
Again, impressive work. However, a fusor would provide vastly more neutrons. Still, I'm sure it was a fun learning experience and if it was the 1950's, no doubt others would try it, too .